Poison-spyder JK ROCKER KNOCKERS Instrukcja Użytkownika Pobierz pdf (Strona 3)

INSTALLATION INSTRUCTIONS

Poison Spyder Customs • JK ROCKER KNOCKERS INSTALLATION Page 3

drilling these holes—the material is thin and

a bit this size can catch and distort the metal.

FIGURE 4

2. (2-door models only) Starting from the

front of the Jeep, count backward to the

fourthholeinthepinchweldange.

FIGURE 5

From the center line of the fourth hole,

measure backward (toward the rear of the

Jeep) 11-3/4” and mark a vertical line in the

pinchweldange.

FIGURE 6

From this mark, measure another 4-5/16”

toward the rear of the Jeep and make another

markinthepinchweldange.

FIGURE 7

Next, measure from the bottom edge of the

pinchweldange,ateachverticalmark,and

make a horizontal mark 5/16” up from the

bottom edge.

FIGURE 8

You should now have two cross-marks on

thepinchweldange.

3. (2-door models only) Center punch and

drill two 1/4” holes through the pinch weld

ange,oneateachcross-markmadeinthe

previous step.

FIGURE 9

Use the 7/16” drill bit to open up the two

holes. Use caution when drilling these holes

as the material is very thin and a large drill bit

1 2 3 4 5 6 7

Brak uwag

Poison-spyder JK ROCKER KNOCKERS Instrukcja Użytkownika Strona 3